MX-M503N MX-FN11 9 – 4
4) Remove the reverse tray.
5) Remove the screws, and remove the interface left cabinet.
6) Remove the screws, and remove the paper pass latch recep-
tion parts and the positioning pin.
D. Attaching the mylar
1) Attach the mylar (package part No.13) to the position indicated
in the figure.
E. Installation of the connection fixture F/R
1) Install the connection fixture R (Package part No. 8) to the
main unit with the fixing screws (Package part No. 3).
2) Install the connection fixture F (Package part No. 7) to the
main unit with the fixing screws (Package part No. 3).
Corner
reference
Corner
reference
Reference
Reference
To Next Page
Loading...
