Sharp MX-M365N - Page 46

TEST SIMULATION
SHARP
46
SHARP Document Solution Centre
24
Data Counter & Clear
1
Jam/trouble counter clear
2
Paper feed counter clear
3
Document feed & output counter clear
4
Maintenance counter clear
5
Developer counter clear
6
Copy Counter clear
9
Print & other counter clear
10
Fax counter clear
12
Document filing counter clear
15
Network scanner counter clear
25
Toner usage estimator counter clear
35
Toner cartridge use status clear
25
DV Auto Adjustment & Monitor
1
Toner sensor monitor (Process drive)
2
Auto developer adjustment setting
4
Toner supply quantity data display
26
Device Configuration
1
Right Tray setup
2
LCC paper size setup
3
Auditor setup
5
A3 Total/Maintenance counter set-up
6
Destination set-up
7
Machine ID setting
8
Long paper mode counter setting
10
Network scan trial mode set-up (MX-AMX1)
18
Toner save operation
30
CE mark control setup
32
Fusing cleaning operation setting
35
Trouble memory mode setting
38
Engine life over setting (Maintenance)
41
Pamphlet mode AMS operation
49
Copy speed mode setup (Postcard)
50
Function setting: (B/W reverse, Finisher,
Long Size print etc).
51
Serial port operation setting (for PCI)
52
Blank paper count mode setting (non
printed paper – insert/cover page)
53
Enable/Disable calibration (gradation)
65
Finisher staple alarm mode set-up
69
Toner near end setting
71
Web browsing trial mode setup
73
Poster enlargement image loss adjustment
74
OSA trial mode setting
78
Remote operation (VNC) password setting.
79
User data delete pop up display
enable/disable
30
Sensor Operation & Test
1
Main unit sensor check
2
Paper feed sensor check (main body)
40
Bypass Operation & Adjustment
2
Bypass tray width adjustment
7
Bypass tray width detection manual setting
41
OSS Operation & Adjustment
1
Document sensor operation check
2
Document sensor output setup
3
Document sensor output display
43
Fuser Setting & Adjustment
1
Fuser temperature setup for each mode
2
Fusing operation and preheating setup
20
Fuser temperature. correction for low
temperature & humidity (L/L)
21
Fuser temp correction for high
temperature & humidity (H/H)
24
Fuser temperature correction setting
31
Fuser web operation check
32
Force operation of web cleaning (job end)
34
Fusing lower web cleaning motor operation
35
Fusing NIP operation check
44
Process Control Data
1
Process control mode setting
2
Process control sensitivity adjustment
4
Process control initial density setup
6
High density process control correction
9
Process control data display
12
DM data, patch/base data display
14
Fuser temp.& humidity output data
15
OPC drum idle rotation setting
17
Process refresh execution
21
Half tone process control registration
22
Half tone process control patch result
24
Half tone correction data result display
25
Initial half tone correction data display
26
Half tone process control execution
27
Half tone process control correction clear
28
Process control timing (On/Off) setting
29
Enable/disable half tone correction (Job)
34
Process control execution setting
37
DV bias correction level setting for
continuous print mode.
43
DV unit installation identification check