DEVELOPER SET-UP
Sim 25-02 Auto Developer Adjustment - Select K.
Toner Installation must be performed after Auto Developer Adjustment is completed.
**For optimum image quality & performance, it is recommended to setup & install
developer at the customer site.
TONER INSTALLATION & REPLENISHMENT
Install K Toner Cartridge
Caution:
DO NOT open any Exterior Cover, Power OFF/ON or enter Simulation Mode during
Initial Toner Replenishment.
PRODUCT ACTIVATION & FIRMWARE UPGRADE
Activation of Optional Product(s):-
System Settings – Administrator Mode – Product Key.
Sim 22-05 Check Firmware version(s):- Upgrade to latest version.
INITIAL SETUP
Sim 26-01 Right Tray Installation Yes/No.
Sim 26-02 LCC Installation (Paper Size):- A4.
Sim 26-06 Machine Destination.
Sim 26-35 Set Multi Error Counter Set to 1 (Multi Count).
Sim 26-50 Long Paper Support (up to 1200mm), 0 = Disable, 1 = Enable.
Sim 26-52 Non Printed Paper Counter Set-up.
Sim 55-03 Process Mixed Size Pages (orientation) when Printing in Duplex:-
SSW 3-6, 0 = Disable, 1 = Enable.
Sim 55-03 Toner Remain Status Display: SSW 22-5, 0 = Disable, 1 = Enable.
System Settings: Adjust Date/Time (Inc. Daylight Saving setting).
Keyboard Language Setting (For Embedded & Optional Keyboards):-
System Settings – Default Settings – Keyboard Select: Set English(US)
Network Settings – Print Port Settings: Disable WSD.
Set cassette size by adjusting the guides in the cassette.
Paper Size & Type Setting:- System Settings – Paper Tray Settings.
IMAGE SKEW [ENGINE]
Sim 64-02 Check LSU Parallelism. Select A=1, B=1, C=254, D=255
To Next Page
Loading...
