AUTO POWER SHUT-OFF TIMER
This mode turns off the power to the operation panel and the fusing unit, and makes the
machine wait in the lowest power consumption state.
Auto Power Shut-Off Timer will activate when the set duration of time elapses in waiting
status without executing a job.
Compared to preheat mode, the power-saving rate is considerably higher but the wakeup
time is longer.
The [Power Save] button blinks when the machine is in Auto Power Shut-Off Timer.
Auto Power Shut-Off Timer is also activated by pressing the [Power Save] button while
the [Power Save] button is not lit.
This mode is cleared when print data is being received, fax data is being output, or when
the [Power Save] button is pressed while it is blinking.
A message appears 15 seconds before Auto Power Shut-Off Mode is entered. To close
the message and continue normal operation, tap the [Continue] button.
The message appears again 15 seconds before the end of the extension of normal
operation time.
If no action is taken within 15 seconds after the message appears, the machine enters
auto power shutoff mode.
To set Auto Power Shut-Off Timer:
In "Setting mode", select [Energy Save] → [Auto Power Shut-Off].
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
101 of 1441 3/17/2016 7:14 AM
To Next Page
Loading...
