USER AUTHENTICATION
*
This setting enables or disables user authentication and specifies the authentication
method.
When the user authentication is enabled, each user of the machine is registered. When a
user logs in, the separate authentication settings apply to the user. This function allows
greater control of security and cost management than that on previous machines.
Even if user information is not stored on the machine, you can directly enter the user
information stored in an LDAP server to log in the machine if necessary. In this case, the
authentication information of the "User" being stored as factory default applies to the
login user. For more information, see "Users stored as factory default".
User Authentication
When [User Authentication] is enabled, the authentication screen appears before an
operation is carried out in any mode except the job status screen
*
.
Log in as an already registered user.
After logging in, you can move freely through the modes.
The login screen appears when a document filing file is used or when a broadcast
transmission is reattempted from the job status screen.
Authentication Method Setting
This selects the authentication method. When using user authentication, be sure to
configure this setting first. The items to be configured for users stored after setting the
user authentication method vary depending on the selected authentication method.
Authenticate a User by Login Name and Password
Standard authentication method using a login name and password.
For the procedure for storing users, see "USER LIST".
For details on login procedures when user authentication is enabled, see "User
authentication" of the "OPERATIONS COMMON TO ALL MODES".
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1015 of 1441 3/17/2016 7:14 AM