Specify whether or not to display with the action panel on the screen.
Display Confirmation Dialog when job is canceled.
When the cancel key is pressed during copying or image sending, this setting displays a
confirmation dialog instead of immediately canceling the job.
Disabling of Job Priority Operation
The job priority function can be disabled. When this is done, the [Priority] key will not
appear in the job status screen.
Disabling of Bypass Printing
This setting is used to disable bypass printing (printing other jobs ahead of a job that has
been stopped
*
because the paper required for the job is not available in any of the trays).
* This does not include cases where the paper ran out during the job.
Key Operation Setting
Time for Accepting Key Entry
This setting determines how long a key in the touch panel must be tapped until the key
input is registered. The time can be set from 0 to 2 seconds in increments of 0.5 seconds.
By lengthening the time setting, key input can be prevented when a key is tapped
accidentally. Keep in mind, however, that when a longer setting is selected more care is
required when tapping keys to ensure that key input is registered.
Disable Auto Key Repeat
This is used to disable key repeat.
Key repeat causes a setting to change continuously not only each time the key is tapped
but while a key is tapped.
Long-touch Detection Time
Select a time when a long key touch is detected.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1081 of 1441 3/17/2016 7:14 AM