saddle finisher malfunctions.
Disabling of Punch
This setting is used to prohibit the use of punch, such as when the punch module of
finisher or saddle finisher malfunctions.
Disabling of Master Machine Mode
Disables the Master Machine mode for tandem printing.
(Normally this setting is not necessary.)
Disabling of Slave Machine Mode
Disables the Slave Machine mode for tandem printing.
(Normally this setting is not necessary.)
Copy Settings
Disabling of Registration/Deletion of Program
Disables the program registration.
Disabling of Bypass-Tray in Duplex Copy
Disables the use of the bypass tray when making 2-sided copies.
The bypass tray is often used to feed label sheets, transparency film, and other special
media for which 2-sided copying is prohibited.
If a sheet of one of these special media enters the reversing unit, a misfeed or damage to
the unit may result.
If special media for which 2-sided copying is prohibited is often used, it is recommended
that you enable this setting.
Disabling of Auto Paper Selection
Disables the Auto Paper Selection function.
When this setting is enabled, automatic selection of paper that is the same size as the
original on the document glass or in the automatic document feeder does not take place.
Disabling Registration of Custom Image
Disables the registration of custom images.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1142 of 1441 3/17/2016 7:14 AM