error occurs. During recalling, you can set the number of recall attempts. Any number from
1 to 15 can be selected.
Interval to Wait Between Recall Attempts (min.) in Case of Error
The interval between recall attempts can be set. Any number of minutes from 1 to 15 can
be selected.
Prohibit Fax Broadcasting
Disables facsimile broadcasting.
Fax Receive Settings
Settings for fax transmission can be configured.
Number of Calls in Auto Reception
Allows you to set a number of ringing tones to sound (between 0 and 15 times) until the
auto receiving facsimile starts automatic fax reception.
Duplex Reception Setting
This is used to have received faxes printed on both sides of the paper.
When this setting is enabled and a fax consisting of 2 or more pages is received (the pages
must be the same size), the pages are printed on both sides of the paper.
Auto Receive Reduce Setting
When a fax is received that includes printed information such as the sender's name and
address, the received image is slightly larger than the standard size. This setting is used to
automatically reduce the image to fit the standard size.
When this setting is enabled, note that the machine will not attempt the call again when
manual transmission or direct transmission is used.
If you select "0" for the number of rings, the machine will immediately answer and begin fax
reception without ringing in auto reception mode.
If Auto Receive Reduce is disabled, the edges of the image outside the standard size
will be cut off. However, the image will be clearer because it will be printed at the
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1255 of 1441 3/17/2016 7:14 AM