THE IMAGE IS TOO LIGHT OR TOO DARK
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Is the image too light? Select an appropriate exposure mode for the original being copie
d and adjust the exposure level manually.
Is the image too dark?
Has an appropriate expos
ure mode for the original t
ype been selected?
Select one of the following modes depending on the original type
.
Text
Use this mode for regular text documents.
Text/Printed Photo
This mode provides the best balance for copying an original
which contains both text and printed photographs, such as a
magazine or catalogue.
Text/Photo
This mode provides the best balance for copying an original
which contains both text and photographs, such as a text
document with a photo pasted on.
Printed Photo
This mode is best for copying printed photographs, such as
photos in a magazine or catalogue.
Photo
Use this mode to copy photos.
Map
This mode is best for copying the light color shading and fine text
found on most maps.
Light original
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1265 of 1441 3/17/2016 7:14 AM