CP/IP Port?
(Windows XP/Server 2003
/Vista/Server 2008/7/8/
Server 2012)
d the [SNMP Status Enabled] checkbox is , it may not be possible t
o print correctly. Change the [SNMP Status Enabled] checkbox to .
See: Software Setup Guide
Is "Connect via" set to [E
thernet] for AppleTalk?
(Mac OS 9.0-9.2.2)
Open [AppleTalk] from the [Control Panels] and make sure that
[Ethernet] is selected in the "Connect via" menu.
Printing is not possible if [Ethernet] is not selected.
Is your computer in an uns
table state?
Restart your computer.
Printing is sometimes not possible when you run multiple applications at
once or there is insufficient memory or hard drive space. Restart your
computer.
Is the machine specified c
orrectly in the application t
hat you are using for printi
ng?
Check whether the machine's printer driver has been selected f
rom the print window of the application.
If the machine's printer driver does not appear in the list of available pri
nter drivers, it may not be installed correctly. Remove the printer driver
and then install it once again.
See: Software Setup Guide
Are the network connecti
on devices operating norm
ally?
Make sure that the routers and other network connection devic
es are operating correctly.
If a device is not powered on or is in an error state, see the manual of t
he device to correct the problem.
Is the I/O timeout setting
too short?
Check with your administrator.
If the I/O timeout setting is too short, errors may occur while writing to
the printer. Ask the administrator of the machine to configure an appro
priate time in "I/O Timeout".
"Setting mode" → [Printer Settings] → [Interface Settings] → [I/O Ti
meout].
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1270 of 1441 3/17/2016 7:14 AM