PRINTING DOES NOT TAKE PLACE AFTER
RECEPTION
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Does a message appear in the
display instructing you to add t
oner or paper, or to take some
other actions? (Printing is not
possible when this screen app
ears.)
Restore printing capability as instructed by the message.
Does a password entry screen
appear?
Enter the correct password using the numeric keys.
[Hold Setting for Received Data Print] is enabled. If you do not kno
w the password, check with your administrator.
"Setting mode" → [System Settings] → [Image Send Settings] →
[Operation Settings] → [Default Settings] → [Hold Setting for Rec
eived Data Print]
Has cut-off printing been disab
led in the setting mode (admini
strator)?
Load the same size of paper as the received fax.
If [Print Actual Size Cut off Disabled] is enabled in [Print Style Sett
ing] in the setting mode (administrator) and a fax is received that is
larger than any paper that is loaded, the fax will be received and sto
red in memory without being printed. (However, when a fax longer t
han 11" x 17" (A3) size is received, it will be printed using multiple
sheets of paper.)
"Setting mode" → [System Settings] → [Image Send Settings] →
[Fax Settings] → [Receive Settings] → [Print Style Setting]
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1287 of 1441 3/17/2016 7:14 AM