AUTO SELECTION OF THE COLOR MODE
DOES NOT TAKE PLACE CORRECTLY
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Are you scanning one
of the following types o
f originals?
When Black & White i
s not selected:
Are there colors
or coloring in
the paper?
When Color is not se
lected:
Is the color in
the original very
light?
Is the color in
the original very
dark, almost
black?
Is only a very
small area of the
original colored?
Specify the color mode manually.
When the color mode is set to [Auto], the machine detects whether the or
iginal is black and white or color when the [Start] key is tapped; however, i
n the cases as shown on the left, automatic detection may not give the co
rrect result.
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1303 of 1441 3/17/2016 7:14 AM