JPEG WAS SELECTED FOR THE FILE TYPE
BUT THE FILE WAS CREATED AS A TIFF FILE
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Did you select [Mono2] i
n color mode?
Change the color mode to [Full Color] or [Grayscale], and then ta
p the [Start] key.
When [JPEG] is selected for the file type and the image is scanned in Mo
no2, the file will be created as a TIFF file.
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1312 of 1441 3/17/2016 7:14 AM