Set the telephone line type.
The machine's dial mode setting must be set to match the type of telephone line
you are using.
* If the setting is incorrect, it will result in dialing failures or cause calls to be made
to the wrong destination.
Checking the date and time
Verify that the correct date and time are set in the machine.
Set the data and time in the setting mode of the machine.
Store the sender fax number.
Store a sender name in [Sender Name] and a fax number in [Fax No.]. Be sure to
configure this information, as it is required for communication.
If the fax function will be used, and, in particular, if reception or timer transmission will
take place at night, do not turn the main power off.
If you want to set the type of telephone line automatically:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax
Settings] → [Default Settings] → [Dial Mode Setting], then tap the [Auto Select]
key.
If necessary, you can set the type of telephone line manually.
To set the date and time of the machine:
In "Setting mode", select [System Settings] → [Default Settings] → [Clock Adjust].
If [Disabling of Clock Adjustment] has been enabled, the date and time cannot be
modified.
In this case, select [System Settings] in "Setting mode" and select [Operation
Settings] to disable the [Disabling of Clock Adjustment] setting.
To store the sender's name and address:
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
528 of 1441 3/17/2016 7:14 AM
To Next Page
