Tap the [Start] key to start scanning of the original.
A beep will sound to indicate that scanning has ended.
When scanning ends, check the number of original sheets and the number of
sheets to be sent and tap the [OK] key to start transmission.
When Job Build mode is used, the confirmation message will appear after
the [Read-End] key is tapped.
On the confirmation screen, the number of scanned original sheets appears
in (A), the number of scanned sides in (B), and the number of sheets to be
sent excluding blank pages in (C).
For example, if five original sheets that include two blank pages are scanned
by duplex scanning, (A) will show "5", (B) will show "10", and (C) will show
"8".
Tap the [Preview] key to check the preview of an image before sending a fax. For more
information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
If this step is not performed within one minute after the above confirmation screen
appears, the scanned image and settings will be cleared and the base screen will reappear.
Scanning will stop automatically and the image will not be reserved for transmission.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
825 of 1441 3/17/2016 7:14 AM