EasyManua.ls Logo

Sharp MX-M365N - Page 827

Sharp MX-M365N
1441 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USING A TRANSMISSION LOG TO RESEND
Tap the [Others] key, and tap the [Original Count] key.
A checkmark appears on the icon.
After the settings are completed, tap the [Back] key.
Tap the [Start] key to start scanning of the original.
When scanning is completed, check the number of original sheets.
The number that is displayed is the number of scanned original sheets, not the
number of scanned original pages. For example, when 2-sided copying is
performed using one original, the number "1" will appear to indicate that one
original sheet was scanned, not "2" to indicate the front-side page and the
reverse side page.
Tap the [OK] key to start transmission.
To cancel the Original Count setting:
Tap the [Original Count] key to clear the checkmark.
Tap the [Preview] key to check the preview of an image before sending a fax. For more
information, see "CHECKING THE IMAGE TO BE TRANSMITTED". However, settings for
this function cannot be changed in the preview screen.
If this function is combined with [Job Build], the count result is displayed after the
[Read-End] key has been tapped.
If this step is not performed within one minute after the above confirmation screen
appears, the scanned image and settings will be cleared and the base screen will reappear.
Scanning will not be completed automatically and the image will not be reserved for
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
827 of 1441 3/17/2016 7:14 AM