5
If voltage fluctuations exceed the allowed range, the device
may stop. (MX-M5050/M5070/M6050/M6070 only)
ENVIRONMENT
The products that meet the ENERGY STAR
®
guidelines carry
the ENERGY STAR
®
logo.
The products without the logo may not meet the ENERGY
STAR
®
guidelines.
SUPPLIES
Standard supplies for this product that can be replaced by the
user include paper and toner cartridges.
Be sure to use only SHARP-specified products for the toner
cartridges and transparency film.
Storage of supplies
Proper storage
1. Store the supplies in a location that is:
• clean and dry,
• at a stable temperature,
• not exposed to direct sunlight.
2. Store paper in the wrapper and lying flat.
3. Paper stored in packages standing up or out of the wrapper
may curl or become damp, resulting in paper misfeeds.
Storing toner cartridges
Store a new toner cartridge box horizontally with the top side
up. Do not store a toner cartridge standing on end. If stored
standing on end, the toner may not distribute well even after
shaking the cartridge vigorously, and will remain inside the
cartridge without flowing out.
• Store the toner in a location that is cooler than 104°F (40°C).
Storage in a hot location may cause the toner in the
cartridge to solidify.
•
Please use SHARP-recommended toner cartridges. If toner
cartridges other than SHARP-recommended toner cartridges are
used, the machine may not attain full quality and performance
and there is a risk of damage to the machine.
Supply of spare parts and consumables
The supply of spare parts for repair of the machine is
guaranteed for at least 7 years following the termination of
production. Spare parts are those parts of the machine which
may break down within the scope of the ordinary use of the
product, whereas those parts which normally exceed the life of
the product are not to be considered as spare parts.
Consumables too, are available for 7 years following the
termination of production.
Safety data sheet
The SDS (Safety Data Sheet) can be viewed at the following
URL address:
http://www.sharp-world.com/corporate/eco/env-info/sds/us/index.html
FOR THE USERS OF
THE FAX FUNCTION
Important safety instructions
• If any of your telephone equipment is not operating properly,
you should immediately remove it from your telephone line,
as it may cause harm to the telephone network.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
•
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
•
Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock
from lightning.
•
Do not use a telephone to report a gas leak in the vicinity of the leak.
• Do not install or use the machine near water, or when you
are wet. Take care not to spill any liquids on the machine.
• Save these instructions.
FAX interface cable and Line cable
To reduce the risk of fire, use only UL-Listed No.26 AWG or
larger telecommunication line cord.
About the Telephone Consumer
Protection Act of 1991
The Telephone Consumer Protection Act of 1991 makes it
unlawful for any person to use a computer or other electronic
device, including FAX machines, to send any message unless
such message clearly contains in a margin at the top or bottom
of each transmitted page or on the first page of the
transmission, the date and time it is sent and an identification
of the business or other entity, or other individual sending the
message and the telephone number of the sending machine or
such business, other entity, or individual.
(The telephone number provided may not be a 900 number or
any other number for which charges exceed local or
long-distance transmission charges.)
In order to program this information into your FAX machine,
you should complete the following steps:
See "Own Name and Destination Set" of User's Manual.
FCC Notice to users
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA.
The fusing unit and paper exit area are hot. When
removing a misfeed, do not touch the fusing unit
and paper exit area. Take care not to burn
yourself.
When loading paper, removing a misfeed,
performing maintenance, closing the front and
side covers, and inserting and removing trays,
take care that your fingers are not pinched.
Products that have earned the ENERGY
STAR
®
are designed to protect the
environment through superior energy
efficiency.
For best copying results, be sure to use
only Sharp Genuine Supplies which are
designed, engineered, and tested to
maximize the life and performance of
Sharp products. Look for the Genuine
Supplies label on the toner package.
!mxm6070_us_sg.book 5 ページ ２０１８年３月５日 月曜日 午後４時５２分
To Next Page
Loading...
