Name: Sharp MX-M5071
Brand: Sharp
Rating: 5 (1 reviews)

To Next Page

To Previous Page

General Problems

THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN

Check Solution

Remove the paper, turn it over, and

reload it. Using a different paper type

may solve the problem.

■ This may improve some states of paper curling.

► Placing the original and adding paper

(page 5)

THE IMAGE IS SKEWED ON THE PAPER

Check Solution

Is too much paper loaded into the

bypass tray?

■ Reload the paper. Load no more than the maximum number of sheets and do not

exceed the indicator line.

The maximum number of sheets varies depending on the paper type setting.

Are the bypass tray guides adjusted

to the width of the paper?

■ Adjust the bypass tray guides to the width of the paper so that they slightly

contact the sides of the paper.

Are the original guides adjusted to the

width of the paper?

■ Adjust the original guides to the width of the paper.

Are you scanning originals of mixed

width? (In a reversing single pass

feeder (RSPF))

■ If the printed image is skewed when you have scanned originals of mixed width,

open the document feeder cover, change the switch position, and place the

originals.

The A position of the switch is for normal scanning. The B position is for scanning

of mixed originals.

Be sure to set the switch back to the A position after the mixed original job is

finished.

Other manuals for Sharp MX-M5071

Questions and Answers:

Need help?

Do you have a question about the Sharp MX-M5071 and is the answer not in the manual?

General