Sharp PN-65SC1 - Supplied Components; Preparing the Remote Control Unit

ENGLISH
5
E
Supplied Components
If any component should be missing, please contact your dealer.
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Liquid Crystal Display Monitor: 1

Remote control unit: 1

Cable clamp: 3

Power cord

Remote control unit battery
(R-03 (“AAA” size)): 2

CD-ROM (Utility Disk): 1

SHARP Display Connect License: 1

Setup Manual (this manual): 1

Touch pen: 1

Tray: 1

Tray mounting screw/
camera mount screw (M3) : 2 each

USB cable: 1

Camera mount: 1

Camera screw (inch thread): 1

Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover
the logo.
Preparing the Remote Control Unit
Installing the batteries
1. Place your nger on the part marked with the ▲, and
then pull the cover off.
2. See the instructions in the compartment and put in the
batteries (R-03 (“AAA” size) x 2) with their plus (+) and
minus (-) sides oriented correctly.
3. Close the cover.