Installation
Rear Connector Layout (con’t)
1. Power Connection (refer to the Rear Connector Layout on pg. 8)
Use only the AC power adapter supplied with the system.
Input: 100~240V AC 1.3A
Output: 12V DC 7A
Plug the 12V AC/DC adapter (as in the figure 1 above) to the PN-
TPC2W7A’s power input jack (as in the figure 2).
2. Power Button
This button will stay lit if the PN-TPC2W7A is powered on. If the
PN-TPC2W7A doesn’t power up after the AC is connected, then
press this button to power up. If normal Windows shutdown is
not shutting down the PN-TPC2W7A, then press this button for
more than 4 seconds will turn off the PN-TPC2W7A. In this case,
run Disk Cleanup in Windows next time the PN-TPC2W7A is
powered up.
To Next Page
Loading...
