>>
<<
On-Screen Display Menu
Example
System Options (Continue)
Public Mode
2. How to exit from Public Mode setup screen
There are the following ways to quit the public mode setup
screen.
Turn off the power with the "POWER" key.
Select "EXECUTE".
3. Public Mode Menu
The guidance is not displayed on screen.
Setup procedure
Turn off the power with the "POWER" key.
To move the cursor up and down, use the “cursor
UP/DOWN” key (remote controller) or “CH ( )/( )” key
(remote controller and Monitor).
To change the settings, use the “cursor RIGHT/LEFT” key
(remote controller) or “VOL (+)/(-)” key (remote controller
and Monitor).
To save new settings, select “EXECUTE” and press
“ENTER” key (remote controller) or "Input" key (Monitor).
4. How to use USB clone
This is the function that copying the one Monitor's user setting
to other Monitors or copying previous user setting to itself.
Cloning is available between the same model.
1. Insert the USB memory to Monitor.
2. Enter Public Mode.
3. Select "COPY MODE".
4. Then select the "TV→USB [Start]".
5. "USB Cloning Finished." message is displyed when it is
finished , then select "Reset" . Monitor will restart.
6. Insert the USB which has the data from Monitor to another
Monitor or itself.
7. Enter public mode.
8. Select "COPY MODE".
9. Then select the "USB→TV [Start]".
10. "USB Cloning Finished." message is displayed when it is
finished , then select "Reset" . Monitor will restart.
11. Comfirm the user setting is copied.
PUBLIC MODE
POWER ON FIXED [ VARIABLE ]
MAXIMUM VOLUME [ 100 ]
VOLUME FIXED [ VARIABLE ]
VOLUME FIXED LEVEL [ 30 ]
RC BUTTON [ RESPOND ]
PANEL BUTTON [ RESPOND ]
MENU BUTTON [ RESPOND ]
AV POSITION FIXED [ VARIABLE ]
ON SCREEN DISPLAY [ YES ]
INPUT MODE START [ NORMAL ]
INPUT MODE FIXED [ VARIABLE ]
LOUD SPEAKER [ ON ]
RC PATH THROUGH [ OFF ]
REMOTE POWON [ ENABLE ]
PUBLIC MODE [ OFF ]
RESET
EXECUTE
COPY MODE
ENG 4-23
To Next Page
Loading...
