>>
<<
On-Screen Display Menu
Example
System Options (Continue)
PUBLIC MODE
13. RC PATH THROUGH
Selection Selection between “OFF”, “ON: Display RCE” and “ON: Display RCD”
Default OFF
Explaination Function to feed the remote controller-received signal to Pin 9 (open) on the RS232C.
Limit in Setting None
Exception None
Remarks When the setting is “ON: Monitor RCD”, Monitor doesn't respond to the RC operation.
14. REMOTE POWON
Selection Selection between “Disable” and “Enable”
Default Enable
Explaination In the standby mode, the power-on by the 232C command is enabled or disabled.
Limit in Setting None
Exception None
Remarks The setting by "RSPW" RS-232C/IP control command has prioriy overthis setting.
15. PUBLIC MODE (ON/OFF)
Selection Selection between “ON” and “OFF”
Default OFF
Explaination In case of “ON”, public mode settings are effected.
Limit in Setting None
Exception None
Remarks The public-mode settings are operable only when this item is set at ON.
ENG 4-28
To Next Page
Loading...
