9
Turning Power On/Off
Caution
• Turn on the monitor rst before turning on the computer or
playback device.
• Even when the power is turned off with the POWER button
on the monitor, a minute amount of power is consumed if
the power cord is connected.
• When turning the power off and back on, always wait
for at least 5 seconds. A short interval may result in a
malfunction.
• For a complete electrical disconnection, pull out the main
plug.
Turning power on/off
1. Press the POWER button on this monitor to turn on the
power.
The power LED lights green.
[PN-UH861]
Remote control sensor Power LED
POWER button
[PN-UH551/PN-UH501/PN-UH431]
Remote control sensor Power LED
POWE
R
button
Status Status of the monitor
Green lit Power on
Red lit Standby mode
2. Turn the power on and off with the POWER button on
the remote control unit.
Point the remote control unit toward the remote control
sensor on this monitor, and press the POWER button.
n
Power save mode
When the monitor is turned on for the rst time after being
shipped from the factory, the power save mode setting screen
will be displayed. Set it to “YES” or “NO”.
YES ...“Power save mode” is set to “On”. Current consumption
is reduced while the monitor is in standby mode. Note,
however, that the startup time from standby mode
becomes longer.
NO .....“Power save mode” is set to “Off”. Startup time from
standby mode is reduced. Note, however, that more
power will be consumed in standby mode.
Even after being set, you can change the “Power save mode”.
(See Operation manual.)
To Next Page
Loading...
