EasyManua.ls Logo

Sharp R-22AM - Power Levels and Cooking Charts; Understanding Power Levels; 1500 W Cooking Recommendations; 1800 W Cooking Recommendations

Sharp R-22AM
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
R-22AM
R-23AM
R-23AT
“ . “ does not appear on display when power cord is plugged into
wall outlet.
Control panel can not accept key in.
Fuse F2 F6.3A blows when the door is opened. 
Home fuse blows when power cord is plugged into wall outlet. 
Weak point F1 blows when power cord is plugged into wall outlet.
Oven lamp, fan motor and stirrer motors do not work for 1 minute
when the door is opened or after cooking.
Fuse F2 F6.3A blows when power cord is plugged into wall outlet. 
Oven lamp does not light when door is opened. (Blower and stirrer
motors work)
Blower motor does not work when door is opened. (Oven lamp
lights and stirrer motors work)
“EE 1” (Magnetron MG1 failure) 
“EE 2” (Magnetron MG2 failure)
“EE 3” (Magnetron MG1 and MG2 failure) 
“EE 6” (Thermistor (1) failure) 
“EE 7” (Exhaust air temperature is high) 
“EE 9” (Exceeded max. heating time) for R-23AT
Oven lamp, blower motor and stirrer motors do not work. 
Oven lamp does not work. 
Blower motor does not work. 
Oven does not stop after end of cooking cycle. (Oven lamp, blower
motor and stirrer motors stop.)
Home fuse blows when starting the oven.
Oven goes into cook cycle but shuts down before end of cooking cycle. 
It passed more than 1 minute after cooking but oven lamp, blower
motor and stirrer motors do not stop.
“EE 16” (Thermistor of MG. and (2) are open.) 
“EE 17” (Magnetron temperature is high.) 
“EE 8” (Relay melt short)
Stirrer motors do not work.
MAGNETRON MG1
MAGNETRON MG2
HIGH VOLTAGE TRANSFORMER T1
HIGH VOLTAGE TRANSFORMER T2
H.V. RECTIFIER ASSEMBLY FOR MG1
H.V. RECTIFIER ASSEMBLY FOR MG2
H.V. WIRE HARNESS
H.V. CAPACITOR C1
H.V. CAPACITOR C2
1ST. LATCH SWITCH SW1 
2ND. LATCH SWITCH SW2 
3RD. LATCH SWITCH SW3
MONITOR SWITCH SW4 
STOP SWITCH SW5
FUSE M8A F3
FUSE M8A F4
FUSE F13A F1
FUSE F6.3A F2
MAGNETRON TEMPERATURE FUSE TF1
MAGNETRON TEMPERATURE FUSE TF2
B. MOTOR TEMPERATURE FUSE TF3
OVEN TEMPERATURE FUSE TF4
MONITOR RESISTOR R1
MAGNETRON THERMISTOR
OVEN THERMISTOR (1)
OVEN THERMISTOR (2)
STIRRER MOTORS SM
BLOWER MOTOR BM
HIGH VOLTAGE FUSE(S) F5, F6
OVEN LAMP OR SOCKET
NOISE FILTER
POWER SUPPLY CORD
FUSE HOLDERS
Shorted wire harness
Opened wire harness
TOUCH CONTROL PANEL
RELAY RY-1
RELAY RY-3 [for R-23AT], RY2 [for R-22AM/23AM]
RELAY RY-4 [for R-23AT], RY3 [for R22AM/23AM]
FOIL PATTERN
Mis adjustment of switches
HOME FUSE or BREAKER
No power at wall outlet
Over the max. cooking time [for R-23AT]
Due to programme lock
Temperature of magnetron thermistor is high.
Temperature of oven thermistor (1) is high.
Temperature of oven thermistor (2) is high.
KEY UNIT [for R-23AT], or SWITCH UNIT [for R-22AM/23AM]
A ABBCC DDEEEEEFFGH I I I I JKKKL LN M OQQQR P
TESTPROCEDURE
POSSIBLE CAUSE
AND
DEFECTIVE PARTS
CONDITION
OFF
CONDITION
ON
CONDITION
PROBLEM

Other manuals for Sharp R-22AM

Related product manuals