Sharp R-9380

R-9380
PIN NO. / 16
1 SIGNAL / P53
I
I/O
j IN
e.-i_----- ~.-.--~ _~~. -..-~
Terminal for manufacture test.
Normally terminal not used.
(FiD931A3U)
PIN NO. 1 17,16
1 SIGNAL
j P6o,P61
I/O
j IN
---
Terminal not used.
(RD93KA2U)
PINNO. 119
1 SIGNAL / P62
I/O
: OUT
--___-
_yi-----.---.
Kev strobe siqnal.
Signal applied to touch-key section.
A pulse signal is input to Pl O-P1 3 terminal while one of D-l line keys on key matrix is touched.
CRD93EAl U)
PIN NO. 1 20
Kev strobe signal.
1 SIGNAL j P63
I/O
1 OUT
-./
-.
Signal applied to touch-key section.
A pulse signal is input to PIO-PI3 terminal while one of D-2 line keys on key matrix is touched.
(RD93BAl U)
PIN NO. j 21
1 SIGNAL / P70
I
l/O I OUT
Kev strobe signal.
Signal applied to touch-key section.
A pulse signal is input to PlO-P13 terminal while one of D-3 line keys on key matrix is touched.
(RD93BAl U)
PIN NO. 1 22
1 SIGNAL 1 P71
I
I/O : OUT
Kev strobe signal.
Signal applied to touch-key section.
A pulse signal is input to PIO-PI3 terminal while one of D-4 line keys on key matrix is touched.
/ RD93BAl Ub
PIN NO. / 23
1 SIGNAL / P72
I I/O
! OUT
Kev strobe siQnal.
Signal applied to touch-key section.
A pulse signal is input to PIO-P13 terminal while one of D-5 line keys on key matrix is touched.
(RD93BAl U)
PIN NO. j 24
SIGNAL I P73 I/O 1 OUT
jam ~--.~ .~ ~~~~.
~~~
___._~
Kev strobe signal.
Signal applied to touch-key section.
A pulse signal is input to PIO-PI3 terminal while one of D-6 line keys on key matrix is touched.
(RD93BAl U)
PIN NO.
i 25
Terminal not used.
._
SIGNAL i KT
I/O
’ IN
iRD93KA2IJ)
PIN NO. / 26
1 SIGNAL
/ KI
1 I/O
IN
_----.-----. -...--.~_ -~ --~
_ ~~-. .-.
-.
Siclnal svnchronized with commercial source frequencv(50Hz).
This is the basic timing for time processing of LSI.
!RD93FEl U:
17