EasyManua.ls Logo

Sharp R-950A - AUTOMATIC OPERATIONS; Auto Reheat

Sharp R-950A
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R-950A
11
CK = Check / RE = Replace
RE SHORTED POWER CORD
CK LOW POWER SUPPLY VOLTAGE
CK WALL OUTLET
CK OPENED OR SHORTED WIRE HARNESS
RE OVEN LAMP OR SOCKET
Q FOIL PATERN ON P.W.B.
P RELAY (RY-7)
P RELAY (RY-6)
P RELAY (RY-5)
P RELAY (RY-4)
P RELAY (RY-3)
P RELAY (RY-2)
P RELAY (RY-1)
O KEY UNIT
N TOUCH CONTROL PANEL
M NOISE FILTER
L MONITOR RESISTOR
K DAMPER MOTOR
K CONVECTION MOTOR
K TURNTABLE MOTOR
K FAN MOTOR
J THERMISTOR 
I GRILL HEATER
I CONVECTION HEATER
H THERMAL CUT-OUT 
H TEMPERATURE FUSE 150˚C 
G MAIN FUSE 20A
F MONITOR FUSE M10A
E DAMPER SWITCH
E MONITOR SWITCH
E
2ND. INTERLOCK RELAY CONTROL SWITCH
E 1ST.
LATCH SWITCH
D HIGH VOLTAGE CAPACITOR
C H.V. RECTIFIER ASSEMBLY
B POWER TRANSFORMER
A MAGNETRON
POSSIBLE CASE AND 
DEFECTIVE PARTS
PROBLEM
CONDITION
OFF
CONDITION
COOKING
CONDITION
COMMON 
MODE
MICROWAVE
COOKING
CONDITION
CONVECTION
COOKING
CONDITION
GRILL
COOKING
CONDITION
Home fuse blows when power supply cord is plugged into wall outlet.
Fuse M10A blows when power cord is plugged into wall outlet.
Display does not show anything when power cord is first plugged into
wall outlet.
Display does not operate properly when STOP/CLEAR pad is touched.
(" : " or the time of day should appear on the display with beep sound
during normal condition.)
Oven lamp does not light with door opened.
Oven lamp does not light at all.
Oven lamp light, but turntable motor does not operate.
Cooling fan motor does not operate.
The oven stops after 1 minute.
Oven does not go into a cook cycle, when START pad is touched.
Low or no power is produced during microwave cooking (The food is
heated incompletely or not heated at all)
Extremely uneven heating is produced in oven load (food).
Function of variable cooking does not operate properly except HIGH
power.
CONV indicator lights, but convection heater does not heat.
Temperature in the oven cavity is lower or higher than preset.
Convection cycle runs 3 minutes then the oven shuts down.
Grill heater does not heat.
Initial back up by convection does not work properly.
SIMUL CONVECTION COOKING CONDITION 
SIMUL GRILL COOKING CONDITION
See above "Microwave Cooking Condition" and "Convection Cooking Condition".
See above "Microwave Cooking Condition" and "Grill Cooking Condition".

Other manuals for Sharp R-950A

Related product manuals