Sharp SA-155H - Specifications; General Description; Amplifier Section; Tuner Section

SA-155H/HB/E
©
Power source:
Power consumption:
Semiconductors:
Dimensions:
Width;
Height;
Depth;
Weight:
FOR A COMPLETE DESCRIPTION OF THE OPERA-
TION OF THIS UNIT, PLEASE REFER TO THE OPERA-
TION MANUAL.
SPECIFICATIONS
GENERAL DESCRIPTION
AC 110V/220V/240V, 50/60Hz (SA-155H/HB)
AC 240V, 50/60Hz (SA-155E)
160W
6 ICs (Integrated Circuits)
9 Transistors
1 FET (Field Effect Transistor)
18 Diodes
8 LEDs (Light Emitting Diodes)
390mm (15-11/32”)
125mm (4-29/32"’)
274mm (10-25/32"')
5.0 kg (11.0 Ibs.)
AMPLIFIER SECTION
Music power output:
Continuous power
output:
Frequency response:
Input sensitivity and
input impedance:
PHONO;
TAPE;
AUX;
Phono overload:
Tone control:
Bass;
Treble;
TUNER SECTION
FM
Frequency coverage:
Quieting sensitivity:
Image rejection:
IF rejection:
Harmonic distortion:
Mono;
Stereo;
Stereo separation:
MW/LW
Frequency range:
MW;
LW;
Usable sensitivity:
MW;
LW;
Harmonic distortion:
2 x 30W/4 ohms
0.8% total harmonic distortion
2 x 20W/4 ohms
0.8% total. harmonic distortion
20Hz — 25kHz (+3 dB)
3.5mV, 56k ohms
150mV, 23k ohms
150mV, 23k ohms
150mV (RMS, 1kHz, 0.3% THD)
+8 dB at 100Hz
+8 dB at 10kHz
87.6 to 108MHz
2uV (40kHz deviation, S/N = 26 dB)
42 dB (at 98MHz)
75 dB (at 98MHz)
0.5%
0.7%
30 dB
526.5 to 1606.5kHz
150 to 285kHz
350uV/m (with bar antenna)
350uV/m (with bar antenna)
1.0%
Specifications for this model are subject to change with-
out prior notice.
VOLTAGE SELECTOR ADJUSTMENT
(SA-155H/HB)
The voltage selector is located on the rear of the unit.
If adjustment is necessary, use a screwdriver in order to turn the
selector in either direction until the correct voltage figure is
displayed in the window next to the adjustment screw.