Sharp SJ-PT56R-HS - Page 30

SJPT56RHS
9 – 6
11)Fix 10) ass'y with paper tape.
12)Fix VR PWB ass'y to R-C box cover.
13)Insert Control knob to 12) ass'y.
14)Fix 13) ass'y with Waterproof tape.
15)Fix 14) ass'y with PWB sheet 55DR.
16)Fix Lamp ass'y to R lamp holder.
17)Fix 16)ass'y to Tapping screw.
18)Insert R-C box AL sheet to R-C box cover
After putting in two notches hole bent it 90
19)Insert Lamp harness to 18)ass'y.
20)Fix 19)ass'y to R-C box cover..
21)Fix R-thermistor to R-C box cover.
22)Stick R-thermistor sealer to R-C box cover.
23)Stick Warning label to R-C box AL sheet.
24)Fix 24) ass'y with paper tape.
25)Insert 11) ass'y to 25) ass'y.
Figure A-16
R-thermistor
Insert of pin
Note
Control knob
Control knob
PWB sheet 55DR
Pins should be insert surely,
and check by pulling it.
PL process
VR PWB ass’y
A
C
B
Rc box cover
Rc box AL sheet
Lamp Ass'y
R Lamp Holder
R-thermistor
Rc box AL sheet
RcboxALsheet
R sir guider a
R sir guider b
Rc box cover
Lamp Ass'y
R Lamp Holder
warning label
Contorol Knob
Control label
Paper Tape
Tapping screw
R Thermistor sealer
Lamp harness
Rlampholder
R Thermistor sealer
PWB Sheet
55DR
VR PWB
Ass'y
Paper Tape
Paper Tape
(30x30mm)
(30x30mm)
(30x60mm)
Control knob
PWB sheet 55DR
VR PWB ass’y