Sharp SJ-WS320TS - Page 47

SJ-WS320T-S
47
6. Door adjusting procedure
CAUTION:
• At the end of adjusting procedure, check the related parts and fasteners for missing and
looseness. Poor installation will cause falling of door.
• Before adjusting, take out the foods from the refrigerator compartment and door pocket.
[Symptom suggesting need of readjustment]
•Door will not open/close smoothly.
•Required operating force for right and left doors are not the same.
•Roller goes down excessively.
[Cause]
[1]Floorisnotlevelornotat.(Therefrigeratormaybedistorted.)
[2] Roller run-on height is large or small.
[Adjustment]
1. When the cause is [1] above, use Adjustable foot.
• Extend the Adjustable foot until the opposite side Adjustable foot is raised.
•While checking opening condition of left and right doors, readjust the Adjustable foot.
2. If the adjustment with the Adjustable foot is not complete (cause [2]), readjust as follows using the spacer kit for
adjustment.
Spacer kit for adjustment
(On some models, these spacers were installed at the factory before shipping.)
Ｒ Ｒ
Ｆ Ｆ
When the right door is heavy.
When the left door is heavy.
Extend the right
Adjustable foot.
Extend the left
Adjustable foot.
R&L SPACER ASS'Y 2010
Parts name
Parts code
CSOG-E127CBKZ
Roller spacer ×4
Door cam spacer ×4
Upper hinge spacer
(For refrigerator door) ×2
（Thickness:0.5ｍｍ）
Upper hinge spacer
(For freezer door)×2
Included
accessory
parts