Sharp SJ-XP680G - Control Panel Operations (SJ-XE680 M, SJ-XE700 M); Mode Selection and Temperature Control; Door Alarm Functionality

12
Control panel
Useful modes
Button Meaning Default setting
Extra cool
OFF
Express freezing
Express cool
Plasmacluster ON *
Controlling temperature
Button Meaning Default setting
Controlling
temperature
of Refrigerator
compartment
Controlling
temperature of
Freezer compartment
* The Plasmacluster operates
automatically when the refrigerator
is powered on.
There is no need to switch on/off.
Operations of useful modes
Start operation
Cancel operation
Extra cool Press the mode button.
(Beep)
Press the mode button.
(Beep)
Express
freezing
Press the mode button.
(Beep)
Press the mode button.
(Beep)
Express cool Press the mode button for
3 seconds or more.
(Beep, Beep, Beep)
Press the mode button.
(Beep)
Flashing
Door Alarm
Note
•If you want to light up the
indicator, press “F” or “R” button.
(Except for “Plasmacluster”)
Lighting
Lighting
Turn off
Turn off
Turn off
•When the refrigerator door is left open for over 1 minute, door alarm sounds once, and again after 1 minute.
•If the door is left open for approx. 3 minutes, the alarm sounds continuously.
•The alarm stops after close the door.
If Door alarm does not stop
If the door alarm does not stop after closing all doors, it is a defect.
Contact the SHARP service center for service.
Method of stopping the door alarm temporarily
•Press “R” button and “F” button simultaneously and continuously for 3 seconds or more.
•The door alarm sounds again after approximately 2 days.
Beep beep beep
(SJ-XE680M, SJ-XE700M
)
(B656)W_1.indb 12 2015/05/22 14:59:31