MODEL
TL-M5200
TL-M4600
LCD MONITOR
RS-232C Specifications and Commands .......... 2
Setting up the Monitor Network Environment ....
10
1. Connecting the Monitor to a Computer ............ 11
2. Setting an IP Address for the Computer .......... 12
3. Setting up a Network Connection for the Monitor ....
14
Controlling the Monitor via LAN ...................... 16
Controlling the Monitor Using Internet Explorer
(Version 5.0 or later) ................................... 16
Confirming the Monitor Status (Status) ................ 17
Controlling the Monitor (Control) .......................... 17
Setting and Adjusting the Monitor
(Settings & Adjustments) ............................ 18
Setting the Security (Network – Security) ............ 18
Making General Settings for the Network
(Network – General) .................................. 19
Setting for Sending E-mail when an Error Occurs
(Mail – Originator Settings) ....................... 19
Setting Error Items and Destination Addresses
to which E-mail is to be Sent when an
Error Occurs (Mail – Recipient Settings) ... 20
Setting Error Items and the URL that are to be
Displayed when an Error Occurs
(Service & Support – Access URL) ............ 20
Setting up the Monitor Using RS-232C or Telnet ....
21
When Connecting Using RS-232C....................... 21
When Connecting Using Telnet ............................ 22
SETUP MENU (Main Menu) ................................. 23
ADVANCED SETUP MENU ................................. 23
View Setting Detail List ([V]View All Setting) ....... 24
Set Items ............................................................... 24
Save Settings and Quit ([S]Save & Quit) ............. 25
Quit without Saving Settings ([Q]Quit Unchanged) ..
25
IP Address Setting ([1]IP Address) ....................... 26
Subnet Mask Setting ([2]Subnet Mask) ............... 26
Default Gateway Setting ([3]Default Gateway) .... 26
User Name Setting ([4]User Name) ..................... 26
Password Setting ([5]Password) .......................... 27
RS-232C Baud Rate Setting
([6]RS-232C Baud Rate) ............................ 27
Monitor Name Setting ([7]Monitor Name) ............ 27
DHCP Client Setting ([8]DHCP Client)................. 27
Disconnecting All Connections
([D]Disconnect All) ...................................... 28
Entering ADVANCED SETUP MENU
([A]Advanced Setup) .................................. 28
Setting Auto Logout Time
(ADVANCED[1]Auto Logout Time) ............. 28
Data Port Setting (ADVANCED[2]Data Port) ....... 28
Carrying out Network Ping Test
(ADVANCED[5]Network Ping Test) ............ 29
Setting of Accept IP Address (ADVANCED[6]Accept
IP Addr(1) – [8]Accept IP Addr(3)) ................. 29
Accepting All IP Addresses
(ADVANCED[9]Accept All IP Addr) ............ 29
Setting of Search Port
(ADVANCED[0]Search Port) ...................... 30
Return to Default Settings
(ADVANCED[!]Restore Default Setting) ............
30
Return to Main Menu
(ADVANCED[Q]Return to Main Menu) ..............
30
Multi Screen Projection .................................... 31
Setting up the Multi Screen Projection
Input Signal................................................. 32
Returning to the Default Multi Screen Setup ....... 33
Notes on the Wide Multi Screen Projection ......... 34
Setting up the Multi Screen Projection Controlling ...
35
Troubleshooting ................................................. 39
SETUP MANUAL
To Next Page
Need help?
General
