Sharp TOUCH DISPLAY - Setting up the Computer; Installing the touch display driver

4
E
Setting up the Computer
To use the touch panel, the touch display driver must be installed and the touch panel must be connected to your computer.
Installing the touch display driver
The touch display driver is a program that enables you to use the touch panel to operate the computer that is connected to the
touch panel.
Caution
• Toinstall,anadministratorname(username)andpasswordarerequired.
• Ifanolderversionofthetouchdisplaydriverisinstalled,remove(uninstall)theoldversionbeforeinstallingthetouchdisplay
driver.(Seepage10.)
• DonottouchthetouchpanelwhenconnectingtheUSBcable.
 Ifyoutouchthetouchpanel,itwillleadtoamalfunction.Inthiscase,disconnectandthenreconnecttheUSBcable.
1. Start your computer.
2. Exit all applications that are running.
3. Connect the USB cable for the touch panel to the computer.
To the USB terminal
of the computer
USB cable (Supplied)
USB port
USB port
LL-S201A
4. Run the setup program.
(1) Double-clickthe“TouchDisplay”folder,andthendouble-clickthe“Mac”folder.
(2) Double-click“SharpTouchDisplay.mpkg”.
5. Click “Continue”.
Followtheon-screeninstructionstoinstallthedriver.
• Ifascreenpromptingyoutoenterthenameandpasswordappears,enterthenameandpasswordoftheadministrator
andclick“InstallSoftware”(or“OK”).
• Ifthe“Whenthissoftwarenishesinstalling,youmustrestartyourcomputer.Areyousureyouwanttoinstallthesoftware
now?”screenappears,click“ContinueInstallation”.
6. Whentheinstallationnishedscreenappears,click“Restart”.
Thiscompletestheinstallationofthetouchdisplaydriver.
Eachtimethecomputerisstarted,thetouchdisplaydriverwillstartautomaticallytoenablethetouchpaneltobeused.