Sharp VC-780E - Page 7

¥,
VC-790ET
2] aw |
JIGDRIVER-6 a
Torque
Driver
JiGTD1200
JIGDRIVER1 10-7
This Screwdriver is used for
adjusting the guide roller height
and X-position.
Special
Bladed
Screwdriver
JiGDRIVERH-4
This Jig is used for adjusting the
tension band and tension plate.
Tension Band and Plate Adjusting Jig
This is used to screw down resin-
made parts: the specified torque is
5 kg.
This Jig is used for height
adjustment of the A/C head.
Box Driver
This Jig is used for height
adjustment of the retaining guide.
JiGDRIVER1 10-4
” a
JiGRVGH-F1i8 =| BU ar
Current
JiGMA0001
contains
Master
Plane
(JiGMP0001)
and
Disk
Height
Adjusting
Jig
ViGRHO001).
Even
though
new
Disk
Height
Adjusting
Jig
UiGRHO002)
covers
greater
height,
This Jig is used for height
Retaining
Guide
Height
Adjusting
Jig
sdjustient
Gt
the
retaining
guide
This Jig is used for height
adjustment of the reverse guide.
Reverse Guide Height Adjusting Jig
this
new
Jig
JiGRHO002)
can
be
used
for
current
JiGRHO001,
but
current
Jig
(JiGRHO001)
cannot
be
used
as
JiGHROO02.Master
Plane
(JiGMPO001)can
be
used
with
JiGRHO001
and
JiGRHOOO2
as
well.