Sharp VC-A592U - Page 28

28
VC-A592U/A593U
VC-A5933U/H992U
VC-H993U/H994U
Figure 4-43.
INSTALLING THE SHIFTER
Figure 4-42.
1. Make sure that the loading gear is at the Phase-Match-
ing point 1 as shown below.
2. Install, paying attention to insert point 5 and release
point 3.
3. For the phase matching at the insert point 1, see the
Phase-Matching point 2 as shown below.
4. Finally fix the inserts 1 and 4.
Capstan
D.D. motor
Drum
Reel pulley
(Bottom side of mechanism chassis)
Sifter
Phase-Matching
point 2
Insert
point 1
Half round notch
Shaft 1
Round mark
Loading gear (T)
Insert
point 3
Insert
point 4
Insert
point 5
Release
point 3
Phase-matching
point 1
Shaft 1
Shaft 1
Shaft 4
Insert
point 2
Rotation
point 2