Sharp VC-A592U

Ref. No. Part No. ★ Description Code Ref. No. Part No. ★ Description Code
93
VC-A592U/A593U
VC-A5933U/H992U
VC-H993U/H994U
PRECAUTION ON FRONT PANEL SET-UP
Cassette cover
Cassette cover
open lever
Cassette housing
Cassette cover
open lever
Cassette cover
open lever
Cassette cover
About 45°
Front panel
1
5
2
4
3
Removing the cassette compartment cover.
1 Open the cassette compartment cover
fully.
2 Remove the center positioner.
3 Slide the cover to the right.
4 Slightly bend the cover.
5 Draw out the left-side rod.
Do not mount the front
panel with the cassette
cover tilted too open.
Otherwise the cassette
cover might wrongly run
on the cassette housing.
Keep the cassette over about
45° open and make sure that
the cassette cover open le-
ver is between the front panel
and the cassette cover. Now
fix the front panel in place.
Before attaching the front
panel in position, make
sure that the cassette cover
open lever is in its right
place (lower-most). If it is
out of position, push it down
with a finger.
FRONT PANEL PARTS(VC-A5933U/H994U)
A
B
C
D
E
F
123456
SHARP
500-7
500-2
500-1
500-4
500-5
500-6
502-3
502
502-2
502-1
500-3
500
503
502-1
502-2
VC-H994U
VC-A5933U
STOP
PLAY
REW
FF