Sharp VC-MH714HM

14
www.sharp.co.uk/support
BASIC OPERATION
HOW TO USE TO MAKE A RECORDING
(VC-MH714HM ONLY)
6.
If you wish to change the
RECORDING
SPEED
, use the
[/]
to highlight SP. Press
[ / ] to select standard play (SP), long
play (LP) or extended play (EP) as required.
7.
Press the SET button to confirm the
programme. The VIDEOPLUS+ menu will
reappear. If you wish to enter further
VIDEOPLUS+ recordings repeat this procedure.
8.
When you have completed entering the timer
settings, press the
MENU
button to
remove the menu from the TV screen.
9. Ensure that the tape on which you
wish to record is inserted into the VCR,
then press the TIMER ON/OFF
button once to place the VCR in TIMER
STANDBY mode. will be shown on
the display.
NOTES:
• You may also access the VIDEOPLUS+ menu by the following procedure:
i.
Press the
MENU
button.
ii.
The VIDEOPLUS+ option will be highlighted. Press the
SET
button to confirm.
Continue from step 2 of this procedure.
• If the symbol flashes a video tape has not been inserted into the VCR.
• If the video tape is ejected when the VCR tries to record the record protection tab has
been removed.
• During recording, press
STOP
to cancel the recording. If there are further
recordings to be made, the VCR will return to Timer Standby.
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
SP / LP :
TAPE
SPEED
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
6.
→
P L USCODE NO . -
ONCE WE E K L Y D A I L Y
7.
SET
SET
TINS-3992UMZZ English.book Page 14 Wednesday, September 12, 2001 9:46 AM