13
www.sharp.co.uk/support
BASIC OPERATION
HOW TO USE TO MAKE A RECORDING
(VC-MH714HM ONLY)
Before you start!
• If the Timer Standby symbol appears on the VCR display, press the
TIMER
ON/OFF
button to remove the symbol.
• Check that the VCR clock is displaying the correct time.
VIDEOPLUS+ allows you to program the VCR to record up to eight programmes using the
VIDEOPLUS+ numbers published in TV listings (refer to your daily newspaper or TV magazine).
1.
Press the PLUSCODE button on the remote
control.
2.
Enter the VIDEOPLUS+ number from the TV
listing using the
NUMBER BUTTONS
.
NOTE:
3.
Press the [ / ] menu select buttons to select
ONCE, WEEKLY, DAILY.
• If you want to make additional recordings at the same
time each day or week, then use
[/]
to select the
WEEKLY, or DAILY option as appropriate.
4.
Press the
SET
button to confirm.
NOTE:
The first time that you use VIDEOPLUS+ to make a
recording on each channel Preset, (PR) may be
highlighted on the On-Screen Display.
5.
Enter the channel number you wish to record
using the
NUMBER BUTTONS
, for
example if you wish to record channel 2 press
0 2
. The VCR will remember this for the future.
See next page to continue
• An ERROR message will appear if you have entered a number that is not a current
VIDEOPLUS+ number. If this happens press
CLEAR
to delete the numbers as
required and enter the correct VIDEOPLUS+ number.
• Check that the menu list agrees with the times shown in the TV listing. If it does not press
CLEAR
to return to the VIDEOPLUS+ menu, and re-enter the correct VIDEOPLUS+
number.
→
P L USCODE NO . -
ONCE WE E K L Y D A I L Y
MENU SET
CLEAR
DISPLAY
PLUSCODE
MODE OSD
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
ZERO
BACK
231
4
To Next Page
Loading...
