Sharp VC-MH715HM - Manually Setting the Clock

31
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
This procedure will allow you to set the clock manually.
1. Press the MENU button.
2. Press the [ / ] menu select buttons to
select SET UP. Press the
SET button to
confirm.
3. Press [ / ] to select CLOCK. Press the
SET button to confirm.
4. Press [ / ] to select either 12 or 24 hour
clock.
5. Press [/] to select TIME. Enter the time
using the
NUMBER BUTTONS or the
[ / ] buttons. If the minutes or hours are
less than 10, enter the leading 0. If using the 12
hour clock enter AM or PM by pressing the
AM/PM button on the remote control.
6. Press [/] to select DATE. Enter the date
using the
NUMBER BUTTONS or the
[ / ] buttons. For example, for 1st April
enter
01 04.
7. Press [/] to select YEAR. Enter the last two
digits of the year using the
NUMBER
BUTTONS or [ / ]. For example, for
2002 enter
02. For the year 2003 enter 03.
8. Press the SET button to confirm.
NOTE:
• You will need to update the clock for Summer/Winter daylight saving.
SET UP
CHANNEL PRESET
CHANNEL SORT
CLOCK
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
CLOCK
MODE T I ME DATE YEAR
24H 0:00 01/04 02
MODE : 24H / 12H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
Remote Control
MENU SELECT
BUTTONS
MENU
SET
3.
4.
SET
SET
SET
TINS-A079UMN1.book Page 31 Monday, November 4, 2002 1:01 PM