OPERATOR’S MANUAL
P 39 / 57
4. Saddle gib is attached to the position between the right side of saddle and the bese dovetail.
a. Loosen the saddle lock lever .
b. Move the saddle to the front part of the knee.
c. Take off the front and rear wiper holders ( F ) of saddles.
d. Clean the slideway and add the lubricant.
e. Use a screw driver to adjust the gib bolts ( E ) in the right front and rear parts of the saddle.
f. Employ the same methods to adjust the work table gib.
g. Lock up the wiper holders ( F ) on the saddle.
Fig.47
To Next Page
Loading...
