OPERATOR’S MANUAL
P 40 / 57
5. Adjustment of knee gib on machine bady:
Saddle gib is attached to the position between the side of saddle and the base slide way.
a. Loosen the lock belt ( A ) by using hexagonal spanner.
b. Take off the wiper holder ( B ).
c. Clean the slideway and add the lubricant.
d. Move the knee to the highest position.
e. Use a screw driver to adjust the bolts ( C ) in the left upward and bottom parts of the knee.
f. Employ the same methods to adjust the work table gib.
g. Restore and lock up the wiper holder ( B ).
FIG.48
To Next Page
Loading...
