29
Basic Operations
OTHERS 1
ENGL I SH
EXECUTE
ON
ON
OFF
–+
BEEP
REMOTE
DEFAULT
PHONES VOL
DEMO MODE
LANGUAGE
RETURN
–+
PHONES VOL
Using Earphones
(Commercially
Available)
Available modes:
Tape Playback, Tape Camera
You can monitor the sound via stereo
earphones (commercially available) during
playback or recording. Stereo earphones
with a 3.5 mm diameter plug can be used
with this camcorder.
Connect the plug of stereo earphones to the
earphones jack on the camcorder as shown
below.
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest
setting.
• The built-in speaker automatically turns off
when stereo earphones are connected to the
earphones jack.
Adjusting the Phones
Volume
Available mode:
Tape Camera
You can adjust the phones volume if sound
through the earphones is difficult to hear.
1 Set the Media Selection switch to V,
then hold down the Lock button and
set the Power switch to v (see page
21).
2 Press the DISPLAY button until the
mode screen appears (see page 31).
3 Press l or m on the Operation
button to select “MENU”, then press
the center of the Operation button.
4 Press l or m to select “EXECUTE”,
then press the center of the Opera-
tion button.
5 Press l or m to select Z, then
press the center of the Operation
button.
6 Press l or m to select “PHONES
VOL” , then press the center of the
Operation button.
7 Press j or k to adjust to the desired
volume level, then press the center of
the Operation button.
8 Press the DISPLAY button to turn off
the menu screen.
Earphones jack
Decrease Increase
To Next Page
Loading...
