How to fix Sharp WH-T36E Water Heater when water is not flow out from Shower ass’y?
If water isn't flowing from the shower assembly of your Sharp Water Heater, first check if the main water valve is closed and open it. Also, verify that the water volume is not closed and open it. Finally, the Push SW. ON-OFF might be defective, requiring a check or replacement of its mechanical parts.
Why is my Sharp Water Heater not producing hot water, even though the ELB and Power lamps are lit, but the Control lamp is not?
If your Sharp Water Heater isn't heating, and the ELB and Power lamps are lit but the Control lamp isn't, the PCB-A might be defective, and you should replace it.
Why is my Sharp WH-T36E Water Heater not producing hot water when the ELB lamp is not lit, and neither are the Power and Control lamps?
If your Sharp Water Heater isn't heating and none of the ELB, Power, and Control lamps are on, it could be due to several reasons. The Push SW. ON-OFF might be defective, requiring a check or replacement of its mechanical parts. Alternatively, the ELB breaker might be tripped or faulty, in which case you should check for electrical leakage or replace the breaker. Finally, the Main SW. might be closed; try opening it.
What to do if water flow out from Shower ass’y of Sharp WH-T36E is too low?
If the water flow from your Sharp Water Heater's shower assembly is too low, the O-ring might be clogged, so you should check and clean it. Also, the shower assembly itself might be clogged; inspect and clean the shower course. Finally, the main water valve may not be open enough; try opening it further to increase the water flow.
What to do if my Sharp WH-T36E is not producing hot water, but the ELB lamp is lit while the Power and Control lamps are not?
If your Sharp Water Heater isn't heating, the ELB lamp is lit, but the Power and Control lamps are not, the thermostat may have tripped (cut off), so try resetting it. Another possibility is a defect in the body valve assembly, which would require checking or replacement. Other potential causes include a defective Reed SW., Volume SW. assembly, or PCB-A, each requiring replacement.
What to do if my Sharp Water Heater is not producing hot water, but the ELB and Power lamps are lit while the Control lamp is blinking or lit?
If your Sharp Water Heater isn't heating, and the ELB and Power lamps are lit while the Control lamp is blinking or lit, the Triac assembly or the PCB-A might be defective, and you should replace the corresponding part.
Why Sharp WH-T36E Water Heater temperature control knob on high but water is not hot?
If you've turned the temperature control knob on your Sharp Water Heater to a high level, but the water isn't getting hot, the PCB-A might be defective, and you should replace it.
Details on adjusting water temperature and flow rate using control knobs and indicators.
Guidelines for proper water pressure, mounting, and initial setup before installation.
Requirements for wiring, breaker installation, and connecting the main power supply.
General| Model | WH-T36E |
|---|---|
| Power Rating | 3.6kW |
| Voltage | 220-240V |
| Frequency | 50/60Hz |
| Water Connection | 1/2 inch |
| Protection | IPX4 |
| Heating Element Power | 3.6kW |
| Weight | 1.5 kg |
| Warranty | 1 Year |
| Safety Features | Overheat Protection, Dry Heating Protection |
| Type | Electric Tankless Water Heater |
To Next Page
