my Zaurus SL-C3000 and SL-C3100 http://www.users.on.net/~hluc/myzaurus/
24 of 212 16/09/2007 12:23
# cp arial.ttf /hdd3/build/lib/fonts
# export QTDIR=/hdd3/build
# cd $QTDIR/lib/fonts
# echo "arial arial.ttf FT n 50 160 s" > fontdir
# makeqpf-arm -display Transformed:Rot0 -A
# makeqpf-arm -display Transformed:Rot270 -A
# cd /hdd3/build
# newipk arial
# cp /hdd3/build/lib/fonts/*.qpf /hdd3/arial/data/opt/QtPalmtop/lib/fonts
# makeipk arial
# su
# reboot
The above assumes you have downloaded makeqpf-arm from trolltech and extracted it to a location
in the PATH, ie /usr/local/bin. Also it is assumed you have ipktools installed.
And finally, the Japanese display character for the ⁄ symbol is ¥. It is incorrectly displayed but the
correct character is being used, so don't worry about it.
Key Mappings
The Zaurus comes with a full QWERTY keyboard and like most notebooks, some special characters
and keys need to be accessed with a function key (Fn) combo. Most of those combos are already
clearly marked on the keyboard, however, some are not marked and some are missing. All of the
following key mappings work for most applications, however, some applications that have
codepages directly compiled into them will not recognise the mappings and ignore them.
The Print Screen key sequence is:
Fn + Shift + c
Navigation keys:
Fn + up arrow = Page Up
Fn + down arrow = Page Down
Fn + left arrow = Home
Fn + right arrow = End
Other useful and unmarked keys:
Shift + - = `
There are other essential keys that need to be mapped. For that install keyhelper
[keyhelper_1.2.2-1_arm.ipk] and put keyhelper.xml into /home/zaurus/Settings and then reload
the key mappings from a console.
# cd /home/zaurus/Settings
# cp /home/zaurus/Documents/custom/keyhelper.xml .
# khctl reload
Installing keyhelper-c3000map [keyhelper-c3000map_0.4_arm.ipk] will also do the above and it
will also enable the keyhelper menus too as shown below:
To Next Page
Loading...
