Sharper Image GIANT CRUSHER 1015453 - User Manual

Printed in China
1-800-374-2744
Sharper Image® name and logo (including the 77 logo) are trademarks or
registered trademarks. Distributed by and © 2022 MerchSource, LLC. Irvine,
CA 92618. All rights reserved.
Model Number: 1015453
CONTENTS
BATTERY INSTALLATION
1 Giant Crusher Truck
1 Remote Control
1 USB-C Cable
1 Sheet of Reusable Flag Decals
REMOTE OPERATION
1. Push the left joystick forward to make the vehicle move forward or pull
back to make the vehicle reverse. The headlights will light up when the
vehicle is moving forward.
2. Push the right joystick left or right to turn the vehicle left or right.
3. Drive and climb over obstacles with the power of 4-wheel drive.
CHARGING THE BATTERY
Removable
Rechargeable
Battery
Removable
Rechargeable
Battery
GIANT CRUSHER
6+
Power Indication LED
Left/Right Joystick
Forward/Backward
Joystick
Power Button
1. The remote control requires 3 AAA 1.5V batteries (not included).
2. Use a tool to press and hold the battery release button on the back of the
remote control.
3. Slide down the battery cover.
4. Insert batteries as indicated in the diagram.
5. Slide the battery cover back into place securely.
The truck uses a replaceable rechargeable battery. If the battery no longer
stays charged, dispose of it properly according to local disposal
requirements.
CAUTION: If the rechargeable battery leaks fluid, dispose of the vehicle
immediately. Do not allow fluid to come in contact with skin or eyes.
1. Make sure the power switch located at the bottom of the truck is turned
to the o position. The battery pack must be installed in the truck.
2. Insert the USB-C charging cable into the port located at the bottom of the
truck.
IMPORTANT: Do not use excessive force when connecting the USB-C
cable. If there is resistance, check alignment and try again.
3. Connect the other end of the USB-C charging cable into your charging
source. The red light indicator turns on while the truck is charging and is
green when the truck is fully charged.
4. Note: The average charging time is approximately 2 hours (via 5.0V/2A
USB wall charger).
5. The LED indicator on the remote will begin to flash when the truck’ s
battery needs to be recharged. The truck will run for up to 15 minutes on
a full charge.
ON/OFF
CHARGING
PORT
OPEN
Battery Cover Release Button

Summary

Remote Operation

Vehicle Movement Control

Control forward/reverse movement with the left joystick. Headlights illuminate during forward motion.

Vehicle Steering

Steer the vehicle left or right using the right joystick.

Obstacle Navigation

Drive and climb over obstacles utilizing the 4-wheel drive capability.

Battery Installation and Charging

Remote Control Battery Installation

Install 3 AAA batteries into the remote control, ensuring correct polarity and battery cover security.

Truck Battery Charging

Charge the truck's battery using the provided USB-C cable. Red light indicates charging, green indicates full charge.

Charging Time and Indicators

Average charge time is 2 hours. Remote LED flashes when truck battery needs recharging.

Pairing Procedures

Solo Driver Pairing

Sync the remote and truck by powering them on sequentially until pairing lights stabilize.

Multiple Driver Pairing

Sync multiple vehicles by keeping them powered on after individual pairing until all players complete syncing.

Maintenance and Safety

Tire Cleaning

Remove orange tread to empty dirt or water from wheels and tires.

General Battery Warnings

Avoid mixing battery types, ensure correct polarity, supervise charging, and dispose of batteries properly.

Rechargeable Battery Precautions

Handle rechargeable batteries with care to prevent puncture, extreme temperatures, or short-circuiting.

Safe Operation Guidelines

Adult supervision required. Drive responsibly, avoid people/animals, water, and moving parts.

Product Care and Storage

Avoid extreme temperatures and direct sunlight. Inspect product for wear before each use.

FCC Compliance Information

FCC Rules Compliance Statement

This device complies with Part 15 of FCC Rules, operating under specific conditions to prevent harmful interference.

Interference Correction Measures

Users can correct interference by adjusting antenna, increasing equipment separation, or changing power circuits.

Overview

1. Function Description
2. Important Technical Specifications
3. Usage Features
4. Maintenance Features
5. Battery Warnings
6. Rechargeable Battery Warnings (Non-Replaceable Battery)

The Sharper Image Giant Crusher is a 4-wheel drive remote-controlled truck designed for off-road driving and climbing over obstacles. It is suitable for users aged 6 and above.

Function Description:

The Giant Crusher truck is controlled by a remote control that allows for forward, reverse, left, and right movements. When the vehicle moves forward, its headlights illuminate. The truck features 4-wheel drive, enabling it to drive and climb over various obstacles. It utilizes an automatic 2.4GHz digital channel selection system, which allows up to 10 individual players to race side by side without wireless interference.

Important Technical Specifications:

• Power Source (Truck): Replaceable rechargeable battery.
• Charging Time (Truck): Approximately 2 hours (via 5.0V/2A USB wall charger).
• Run Time (Truck): Up to 15 minutes on a full charge.
• Charging Port (Truck): USB-C.
• Power Source (Remote Control): 3 AAA 1.5V batteries (not included).
• Wireless Technology: 2.4GHz digital channel selection system.
• FCC Compliance: This device complies with Part 15 of the FCC Rules, ensuring it does not cause harmful interference and accepts any interference received.

Usage Features:

• Remote Control Operation:
  • The left joystick controls forward and reverse movement. Pushing it forward moves the vehicle forward, and pulling it back moves it in reverse.
  • The right joystick controls left and right turns. Pushing it left turns the vehicle left, and pushing it right turns it right.
• Battery Installation (Remote Control):
  1. Requires 3 AAA 1.5V batteries.
  2. Press and hold the battery release button on the back of the remote control.
  3. Slide down the battery cover.
  4. Insert batteries according to the polarity diagram.
  5. Slide the battery cover back into place securely.
• Charging the Truck Battery:
  1. Ensure the truck's power switch is in the "off" position.
  2. Install the battery pack in the truck.
  3. Insert the USB-C charging cable into the port at the bottom of the truck. Avoid excessive force; check alignment if there's resistance.
  4. Connect the other end of the USB-C cable to a charging source.
  5. A red light indicator turns on during charging and turns green when fully charged.
  6. The LED indicator on the remote control will flash when the truck's battery needs recharging.
• Pairing (Solo Drivers):
  1. Ensure both the truck and remote control are powered off.
  2. Power on the remote control; its LED indicator will slowly flash, indicating pairing mode.
  3. Power on the truck by flipping its power switch and placing it on a flat surface; its headlights will slowly flash, indicating pairing mode.
  4. Wait for both the truck and remote control to stop flashing. The truck headlights will turn off, and the remote control LED will remain lit, confirming successful pairing.
  5. If pairing fails, wait 60 seconds, then power off both devices and repeat steps 2-4.
  6. Begin driving.
• Pairing (Multiple Drivers):
  1. Ensure all RCs and remote controls are powered off.
  2. Each player should sync their RC and remote control one by one, following the solo driver steps.
  3. After syncing, each vehicle must remain on until all players have completed their syncing process.
  4. If any vehicle has syncing problems, all drivers should turn off their remote controls and RCs and restart the process.
• Sleep Mode: To conserve battery life, the truck and remote control will enter sleep mode if not used for more than 5 minutes. Restart and pair if necessary.

Maintenance Features:

• Cleaning Wheels/Tires: If dirt or water gets inside the wheels/tires, the orange tread can be removed to empty it out.
• Water Resistance: The truck is designed with water resistance to protect against accidental splashes and moisture only. It should not be submerged in water or driven through water.
• Moisture in Tires: If moisture accumulates in the tires, carefully remove the center bands, rotate the tires to allow drainage, and then carefully replace the center bands once fully drained.
• Battery Disposal: The truck uses a replaceable rechargeable battery. If it no longer holds a charge, dispose of it properly according to local disposal requirements.
• Fluid Leakage: If the rechargeable battery leaks fluid, dispose of the vehicle immediately and avoid contact with skin or eyes.
• Charger Inspection: Battery chargers used with the product should be regularly examined for damage to the cord, plug, enclosure, and other parts. If damaged, they must not be used until repaired.
• General Safety Precautions:
  • Adult supervision is recommended.
  • Drive responsibly and ensure clear paths, avoiding people or animals.
  • Keep fingers, hair, and loose clothing away from tires and moving parts.
  • Avoid extreme temperatures and direct sunlight for prolonged periods.
  • Thoroughly inspect products before each use. Discontinue use and discard if worn, frayed, splintered, cracked, or broken.

Battery Warnings:

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Alkaline batteries are recommended; use only specified voltage.
• Insert batteries with correct polarity.
• Always use, replace, and recharge batteries under adult supervision.
• Do not charge non-rechargeable batteries.
• Do not short-circuit battery supply terminals.
• Do not dispose of batteries in fire, as they may explode or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep instructions for future reference.

Rechargeable Battery Warnings (Non-Replaceable Battery):

• Risk of fire and personal injury if punctured, damaged, or misused.
• Do not dismantle, crush, incinerate, or short-circuit the battery.
• Never expose the battery to extreme temperatures or moisture.
• Keep away from flammable materials and direct sunlight.
• Only charge using the provided charger, cable, and/or adapters.
• Rechargeable battery must only be charged by an adult.
• Adult supervision is required while the battery is charging.
• Allow the battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products.
• Discontinue charging if the battery becomes hot, swells, smokes, or emits a strong odor.
• Battery chargers must be regularly examined for damage and not used until repaired.
• Recycle or dispose of the battery according to federal, state, and local laws.
• Keep instructions for future reference.

Sharper Image GIANT CRUSHER 1015453 Specifications