Sharper Image SPASTUDIO

To Next Page

SPASTUDIO

™

TOWEL WARMER

SHARPER IMAGE

NAME AND LOGOS (INCLUDING

THE 77 LOGO, TOMORROW’S TOMORROW, AND

SPASTUDIO) ARE TRADEMARKS OR REGISTERED

MERCHSOURCE, LLC. IRVINE, CA 92618. ALL RIGHTS

RESERVED.

FOR CUSTOMER SUPPORT, PLEASE CALL

1-800-374-2744.

MODEL NO.: 1012713

Printed in China.

Please read all instructions and warnings

prior to use.

Keep this manual as it contains important

information for future reference.

CONGRATULATIONS ON

YOUR NEW SPASTUDIO

™

TOWEL WARMER.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.

Note: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and

receiver.

—Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV

technician for help.

Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

CARE INSTRUCTIONS

• After use, always leave the lid open. Allow towel warmer to

cool down completely and then wipe away any interior

condensation.

• To clean exterior, unplug and wipe with a damp cloth.

• Allow to dry fully before plugging in again.

• Do not submerge in water.

• Do not use detergent or soap when cleaning.

SAFETY WARNINGS: PLEASE

READ BEFORE USE

• Not a children’s item. Keep out of the reach of children.

• Do not touch interior surfaces of the towel warmer until cool.

When powered on, surfaces become hot in as few as 3

minutes.

• Do not use attachments of any kind other than those that

may be included.

• Do not leave this item unattended when it is plugged in.

• Always allow item to cool if it becomes too hot.

• Never touch the charging cable or ports with wet hands.

• Do not carry this item by the charging cable or lid.

• For indoor use only.

• Thoroughly inspect products before every use. If the product

appears worn, frayed/splintered, cracked, or broken in any

manner, discontinue use and discard immediately.

Need help?

Do you have a question about the Sharper Image SPASTUDIO and is the answer not in the manual?

Summary

Safety Warnings

General Safety Precautions

Read all safety warnings before use, keep away from children, and inspect product for wear.

Hot Surface Warnings

Surfaces become hot quickly; do not touch interior surfaces until cool; avoid wet hands on charging cable.

FCC Statement

FCC Compliance and Interference

Device complies with FCC Part 15, may not cause harmful interference, and must accept received interference.

Operating Instructions

Initial Setup

Unwrap cord, plug into grounded outlet, and open lid by pressing front of lid.

Warming Towels

Fill with towels, close lid, press power button, and note LED indicators (blue then red).

Warming Duration and Auto Shut-off

Towels warm for 10-15 minutes, continue up to 45 minutes, then auto-shut off.

Removing Towels

Press lid to pop up, lift, and carefully remove warm towel.

Standby and Off Functions

Standby Mode Activation

Lifting lid during heating enters standby mode; power button will flash.

Turning Off the Device

Press and hold the power button to turn off the towel warmer.

Post-Use Cooling

Leave lid open after use, allow to cool completely, and wipe interior condensation.

Optional Aromatherapy

Aromatherapy Setup

Remove diffuser basket, add essential oil to disc, insert back into warmer.

The device described in the manual is the SPASTUDIO™ Towel Warmer by Sharper Image.

Function Description

The SPASTUDIO™ Towel Warmer is designed to heat towels, bath sheets, or bathrobes, providing a spa-like experience. It can warm up to 3 bath towels, 2 bath sheets, or 1 bathrobe at a time. The device also features an optional aromatherapy function, allowing users to infuse their warmed towels with essential oils.

Important Technical Specifications

Model Number: 1012713
Capacity: Up to 3 bath towels, 2 bath sheets, or 1 bathrobe.
Warming Time: Towels warm in 10-15 minutes.
Automatic Shut-off: The towel warmer automatically powers off after 45 minutes of continuous warming.
Power Indicator: The power button illuminates when activated. LEDs underneath the warmer glow blue when warming starts and turn red after 10 minutes.
Safety Features:
- Surfaces become hot quickly (as few as 3 minutes) when powered on.
- Automatic standby mode if the lid is lifted during heating.
- FCC compliant (Part 15) for digital devices, designed to prevent harmful interference.

Usage Features

Setup:
1. Unwrap the cord from the bottom, extend to the necessary length, and lock it in place.
2. Plug the cord into a grounded wall outlet.
Loading:
1. Gently press down on the front of the lid to make it pop up, then lift the lid fully open. Avoid forcing the lid past its normal range to prevent damage.
2. Place up to 3 bath towels, 2 bath sheets, or 1 bathrobe inside. For faster warming, unfold or unroll towels. For the fastest warming, heat a single towel by draping it over the center divider.
3. Close the lid and press down gently until secured.
Operation:
1. Press the power button on the front of the unit. The button will illuminate, and the LEDs underneath will glow blue.
2. Wait 10-15 minutes for towels to warm. The LEDs will turn red after 10 minutes.
3. The warmer will continue warming for up to 45 minutes, then automatically power off.
Retrieving Towels:
1. When ready, gently press down on the lid until it pops up, then lift the rest of the way.
2. Carefully remove the warmed towel.
Standby and Off:
- If the lid is lifted during heating, the warmer enters standby mode (the power button will flash).
- To turn off the warmer, press and hold the power button.
Aromatherapy (Optional):
1. Locate the diffuser basket inside the warmer and remove it by twisting counterclockwise.
2. Add several drops of essential oil (not included) to a diffuser disc (included).
3. Insert the diffuser disc into the basket and reattach it to the interior of the warmer.
4. Use the towel warmer as normal.

Maintenance Features

After Use: Always leave the lid open after use. Allow the towel warmer to cool down completely.
Cleaning:
- Wipe away any interior condensation after cooling.
- To clean the exterior, unplug the device and wipe with a damp cloth.
- Allow to dry fully before plugging in again.
- Do not submerge the device in water.
- Do not use detergent or soap for cleaning.

Safety Warnings

Not a children's item; keep out of reach of children.
Do not touch interior surfaces until cool, as they become hot quickly.
Do not use attachments other than those included.
Do not leave unattended when plugged in.
Allow the item to cool if it becomes too hot.
Never touch the charging cable or ports with wet hands.
Do not carry the item by the charging cable or lid.
For indoor use only.
Thoroughly inspect the product before every use. Discontinue use and discard immediately if worn, frayed, splintered, cracked, or broken.
Changes or modifications not expressly approved by the responsible party could void the user's authority to operate the equipment.