AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 3
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Carefully read this manual before using this appliance.
Ensure that you know how the appliance functions and how to operate it.
Maintain the appliance in accordance with the instructions to ensure that
it functions properly.
Keep this manual with the appliance. If the appliance is to be used by a
third party, this instruction manual must be supplied with it.
The safety instructions do not by themselves eliminate any danger
completely and proper accident prevention measures must always be
used.
No liability can be accepted for any damage caused by non-compliance
with these instructions or any other improper use or mishandling.
Do not use this appliance if it has been dropped or damaged in any way, or if
the supply cord is damaged.
Intended Use
Indoor domestic use only: this appliance is intended for indoor domestic
use only. Do not use it outdoors. Do not use in moving vehicles or boats.
Intended Purpose: Do not use the appliance for anything other than its
intended purpose, and only use it as described in this manual
Accessories: Do not use any accessories with the appliance that are not
supplied or specifically recommended.
WARNING: Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are the type recommended by the
manufacturer.
Supply Cord and Plug
Always unplug from mains supply when not in use. Do not abuse or damage
the power cord. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in order to
avoid a hazard.
Ensure that the socket is located near the appliance and easily accessible in
order to quickly unplug the appliance from the mains in the event of an
operating problem. Always pull out the plug from the socket (pull on the plug,
not the cable)
To Next Page
Loading...
