AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 9
Wiring Diagram
Troubleshooting
Not plugged in.
The circuit breaker tripped or a blown fuse.
Turns on and off
frequently.
The room temperature is hotter than normal. A large
amount of bottles has been added to the unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly. The
door gasket does not properly seal.
The unit does not have the correct clearances.
Check to ensure that the unit is level.
Check the fan.
The unit seems to make
too much noise.
The rattling noise may come from the flow of the
refrigerant. This is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your unit.
Contraction and expansion of the inside walls may
cause popping and cracking noise.
The unit is not level.
The door will not close
properly.
The unit is not level.
The gasket is dirty or bent.
The shelves, bins, or baskets are out of position.
To Previous Page
Loading...
