False alarm control
The Device features a False Alarm Control, which, when activated, will silence unwanted
alarms for up to 10 minutes.
Press and release the control button during an unwanted alarm to silence the alarm
buzzer. This will set the Device in False Alarm Control mode.
If the smoke alarm device does not go into False Alarm Control mode and continues to
sound its loud alarm signal, or if it initially goes into False Alarm Control mode and then
resounds the alarm, the smoke is too heavy and could be a possibly dangerous situation,
take emergency action.
Battery replacement
When the battery becomes low, the smoke alarm device will beep once every 53 seconds
(low battery warning).
You must replace the battery with a new one immediately to continue your protection.
Rotate counterclockwise the Device out of the mounting bracket.
Replace the battery with a new one.
⚠CAUTION! Replace only with the same or equivalent type! Danger of explosion if the
battery is incorrectly placed.
Testing
This unit has been designed to be as maintenance-free as possible, but there are a few
To Next Page
Loading...