Battery Charging
Charging Procedure
Follow these steps for charging your bike from Shengmilo:
1. Ensure the battery is off by inspecting the key port markings (1, below). If needed, align the key port
2. with the "LOCK" icon by inserting the key into the key port and rotating to align the key with the off icon as
shown (at right).
3. Remove the rubber cover on the charging port (2, below) on the opposite side of the battery from the
key switch.
4. Plug the charger into the batter/s charging port. With the battery on or off the bike, place the charger in
a flat, secure place, and connect the DC output plug from the charger (round barrel connector) to the
charging port on the side of the battery (2, below).
5. Plug the charger into a power outlet. Connect the charger input plug (110/220-volt plug) to the power outlet. Charging
should initiate and will be indicated by the LED charge status lights on the charger illuminating as a red light.
6. Unplug the charger from the outlet, then the charging port. When fully charged, from a red charging light to green, first unplug the
charger from the wall outlet, then remove the charger output plug in from the battery charging port.
Always charge your battery in temperatures between 50 °F - 77 °F (10 °C - 25 °C) and ensure the battery and charger are not damaged before
initiating charge. If you notice anything unusual while charging, please discontinue charging and use of the bike and contact Shengmilo
Product Support for help.
To Next Page
Loading...
