Assembly Instructions
◆ Handlebar Installation ( 4mm Hex Wrench )
Step 1: Loosen the bolts on your bike stem.
Step 2 : Center your handlebars and rotate them to align to the marking pointed to in the below image.
Step 3::
Tighten bolts to handlebar stem, but don’t tighten completely as you may want to further adjust the angle later to align more
precisely. After determining the best position, completely tighten all the bolts on the stem. When connecting the front brake power-off cable
plug, make sure the arrows are aligned.
NOTE: Disconnect
the front brake cable
before installing the
handlebar.
To Next Page
Loading...
